Activity Stream

Anyone else feel like this is what Ford wants, and not the consumer? ...

What’s everyone’s thoughts? Seems to be the new way to broom anything. What about the spot cost vs value. If you’re only paying $100 for a...

It's time for our annual blizzard party! Since we always seem to pick a day that has a snowstorm these past few years, why not do it again! ;) ...

Looking into new lighting for my 2 1/2 car garage. Currently have 6 4foot florescent lights but looking into some new brighter led bulbs or maybe...

Happy Birthday old balls!

All the "Support LID" signs are gone

Looking for a custom length drive shaft for my 69 Mustang. I have a list of shops that aren't local, I'd prefer to use a local shop if possible. ...

The Tesla Cybertruck was released last night. Outside of the obvious here, the tri motor AWD version boasts 0-60 in 2.9 seconds and a 500+ mile...

I have a 2013 police package Tahoe 2wd pursuit SUV (82,000 miles). These do not come from the factory with a trailer hitch, they are not rated for...

Is there one planned this year ?

Just got my jeep back from the shop that did an install for me. They also tuned it. But immediately it started having issues. Intermittent issues. ...

There's an instrument cluster I want to buy for my pickup and it's up in Clinton Township, kinda a drive for me. Was wondering if anyone would be...

1954 Studebaker Panel Wagon - Pro Street Entire car -Inside and Out - Has been stripped and E-Coated Chassis has also been E-Coated Car is ready...

I have no real idea of what to expect, I believe there’s 25 questions per section so looking at 100 questions with 72 correct needed to obtain a...

https://www.dodgegarage.com/news/article/showcase/2019/12/the-perfect-drag-car.html

Left and right fox Mustang doors off rust free southern car, very nice bodywork and paint (removed from my car). No dents or damage, ready to scuff...

Enjoy the day and don’t eat too much.

I have a 1.6HP 33gallon Craftsman air compressor. It's one of the 120v oilless units, and the motor/pump/etc is basically all 1 unit under a large...

Big thanks and shoutout to ZYA_LTR for a smooth and easy pistol transfer. Would recommend him and will be using his service again in the future

I'm looking to add bearings to a titanium handled pocket knife, and I was wondering if you guys had any recommendations for a machine shop who could...

Throwing this up here before I send it off to the junkyard. Not looking to pull drivetrains and stuff like that - I just want it gone with as little...

What do you have near Macomb? Needs to be 59" OD Flange to flange and a Limited Slip. Ratio not really that important but a 3.42'ish is...

Anyone have a good contact for a drywall person on the east side?

Loooong story short. Mother in law needs to get the "family lawyer" who is the executor of the trust to do his job. It's approaching 5 years now...

I've been playing with the idea of swapping an IRS (SN95 Cobra/TBird or S550, depending) into my 1951 F1. Does anyone have anything for a good...

anyone have one?

Can a non world class v8 t5 from a 1983 or 84 mustang be rebuilt to world class t5?

Hey guys, I have a commercial building with a title issue. I spoke to a real estate attorney and he said he can have a company run the title...

I’m thankful for God’s promise & provision.