PDA

View Full Version : Gas powered RC 1/8 scale Truggy


DannyDodge
02-09-2009, 07:02 PM
Robitronic 1/8 scale mantis

less than a gallon of gas ran through it, has a Jammin' pipe on it, original stock pipe comes with it, 2 bodys original and a hummer, replaced factory wing with a better carbon fiber wing, its ready to run for make reasonable offer

http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXPHA6&P=ML

http://motownmuscle.com/forums/files/27314990c374cdd9e.jpg


FEATURES: Chassis: Aluminum 0.12" (3mm) thick anodized red in color, with front and rear composite braces Drive: Four wheel shaft drive Engine: Axial .28 Spec 1s with pull starter, SG (pilot) crankshaft glow plug, slide valve carburetor, two stage foam air filter, fuel filter Exhaust: Polished aluminum tuned pipe w/header Fuel Tank: 5.1oz (150cc) with flip top cap Radio: 2-channel 27MHz AM with dual rate steering, steering and throttle trim and reverse, high torque laydown steering servo, charging jack on transmitter Clutch: 3-shoe, 13 steel tooth clutch bell Transmission: Single-speed Ball Bearings: Full set, sealed Shocks: Four oil-filled, with coil-over spring, hard anodized aluminum bodied 3.5mm shafts and 14mm pistons, aluminum 0.16" (4mm) thick shock towers Main Gear: 52 tooth Gearboxes: Sealed Differentials: Bevel gear, floating front and rear diffs, ultra low design for lower center of gravity Brakes: Dual disk Tires: Axial Terra-izer block pattern tread, width 2.9" (75mm), outside diameter 5.8" (147mm), inside diameter 3.1" (80mm) Wheels: White dish style 2.2" (56mm) wide, 3.5" (88mm) diameter, 17mm hex Body: Painted and trimmed truggy style with molded composite wing, color scheme is white and red with gray and black trim Bumpers: Front and rear composite, black in color Suspension: Adjustable, with rubber dampened hinge pin pivot points front and rear anti-sway bars Caster: Adjustable, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis Camber: Adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle Steering: Bushing supported bell-crank with servo saver Warranty Period: Two year limited

dave89iroc
02-09-2009, 07:53 PM
gas, or nitromethane?

DannyDodge
02-09-2009, 07:59 PM
gas, or nitromethane?

nitro

DannyDodge
02-12-2009, 11:50 PM
ttt

BADBIRD
02-14-2009, 09:58 AM
Danny
call me I am interested in this truggy

Ron 734-776-5987

DannyDodge
02-14-2009, 11:02 PM
Danny
call me I am interested in this truggy

Ron 734-776-5987

ok ill hit you up tomorrow, any certain time

BADBIRD
02-16-2009, 02:14 PM
anytime is fine

Ron 734-776-5987

DannyDodge
02-20-2009, 03:41 PM
pending!

DannyDodge
03-09-2009, 08:36 PM
TTT

DannyDodge
03-11-2009, 06:10 PM
Bump

DannyDodge
03-25-2009, 02:47 AM
Hmmmm

slickstang
03-31-2009, 09:13 PM
I'll give ya $10.00 and buy you a pizza

BUMP

DannyDodge
06-24-2009, 09:14 PM
bump

slickstang
06-24-2009, 09:32 PM
I'll give ya $10.00 and buy you a pizza

BUMP

x2

DannyDodge
07-24-2009, 12:47 AM
bump


make offer

DannyDodge
07-29-2009, 11:58 AM
ttt

DannyDodge
08-10-2009, 04:51 AM
ttt



:thumbsup: