Attachment 78341
Attachment 78342
I built a bar...
Printable View
Attachment 78341
Attachment 78342
I built a bar...
Couldn't get any bites on the 77 C10 with Ls swap so I tore it down to the frame, purchased a porter built coil over system for front and rear (no air ride bs that's not my style). Hopefully soon I will find a new cab without a sunroof, running disc brakes on all 4's with potentially a small turbo on the 5.3
finally collecting the parts for the 2008 "unicorn" GT... hopefully my Synopse 50mm waste gate will be here tomorrow... then next month I'll order the turbo... last month I put a new lower radiator support and aluminum radiator in it... this month I hope to have all the rings file fit and have the block sent out again because the machinist forgot to align hone it...
Still workin on my chassis..........
No bumper brackets - Rear Frame/Fuel tank mount in wrong position - Body mount position Okay
Attachment 78359
Leave Body Mount - Cut Center Section Out and tack extensions on for now
Attachment 78360
Clamp rear bar and fabbed bumper brackets into position. Need to make a support for loose end of bumper bracket. I think I am going to finesse the rounded edge of the body mount a bit. I'll probably end up making an entire new body mount.....
Attachment 78361 Attachment 78362
^ Looking good. That chassis is going under the Chevelle, correct?
The car is kinda lonely right now. After I finish up that rear mount, I'll send the chassis off to be re-powdercoated....
Attachment 78363
Hmm not working on... finishing my basement LOL