We did mine in my garage and I am no fabricator either. I bought my material from Van Huron Steel in Belleville and it cost around $75 for the material and took about three days at a few hours a piece to complete.
We did mine in my garage and I am no fabricator either. I bought my material from Van Huron Steel in Belleville and it cost around $75 for the material and took about three days at a few hours a piece to complete.
I have through the floor sub frames on my LX, along with jacking rails. They were done in CA, so I don't know what you could expect to pay for them here in MI... I assume more than $1K.
Talk to Greentrunk about them....Believe he just put them in his car
Word, its easy, did it in the garage, and I ain't no fab guyOriginally Posted by LilJuicedCoupe
Regulator Racing
I'll drop my car off when your ready
I have a bad case of Automotive A.D.D.
WWW.DETROITRACING.COM
Now this is an acceptable use of photos and video's in the Pub.
Lmao, dude you can figure it out I'm sure, go buy the material, there are a couple of holes in the floor you can stick your finger in and feel the frame, its exactly 2" wide, use a cut off wheel and cut the floor on the inner edge of the frame towards the front, then you gotta make room where the seat humps are, lay your steel down and have someone weld, then cut 2 pieces on a 45 for the backs and 2 straight for the front and weld in, your done.....I'll drop my car off when your ready
Regulator Racing
Do you have the entire interior out? If so $500 is a good price, you’ll spend ½ that in material.
yea, but too bad billy closed up shop.
under $100 raw for material that needs cutting.
a pre-cut kit from team z is around 250 i believe.
Cost me around 50 bucks to do mine and thas only cuz i had to fill the damn bottle on the welder thanks to the lil bro leaving it on...
I'm insanly busy right now but if you want them done in a few weeks I'd do them for ya..
I think where most of you have your problems with all of this, is the fact that you really don't fully understand the internal workings and dynamics of the common combustion engine. There is no magic tune up, and motors are stupid. The only time a motor will complain is when something is wrong.
Hmmmmm I want some
Sent from my PC36100 using Tapatalk 2
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks