Dodge Demon

[dline]

They should nickname it livernois killer

[Golden]

Fender flares....

[dline]

IMG_7947.JPG
757 and 815 numbers again

[sardeanie]

IMG_7947.JPG
757 and 815 numbers again

I noticed that too. Either torque and hp or the first 2 steps of hp with the third being on race gas and yet undisclosed. Just a guess like everyone else. April 11 is coming. Day after my birthday so I'm counting down.

[BrainFearGone]

Really hope this is the final widebody look.

IMG_2114.JPG

[soap]

Just because there are holes in the sheet metal of the fenders doesn't mean there will be external rivets showing on the flares. Those fender flares could have "christmas trees" or body clips molded into the backside of them that just push into the sheet metal.

--Joe

[BrainFearGone]

That was my thought. Wouldn't make sense to go from the plastic flare on the rear bumper section to a one piece metal quarter with a flare.

[Krazybones]

I worked at JNAP where the Cherokee and Durango's are made for a few years. I managed the Final Inspection area after Final... and the SRT Jeep Cherokee's have stick on wheel flares similar to the ones pictured above. Always had problems with the actual Assy of them put on or seated correctly. My guess is they will go with a stick on as well (Chrysler fashion) as then they wont have to stamp out different sheet metal just for a low volume Demon (Maybe not)

[DeFormula]

It is really hard to imagine them building the cars with the screws showing. That would be so cheezy. Ah fink dey got mo class din dat. (Friday night after work beer talkin!)

[dline]

Its already different sheet metal with the new holes shown support area for adding the flares, seems like they couldve just added some sheet metal flares, since they are already making unique demon fenders for the stupid flair addons, as in that picture posted earlier

I worked at JNAP where the Cherokee and Durango's are made for a few years. I managed the Final Inspection area after Final... and the SRT Jeep Cherokee's have stick on wheel flares similar to the ones pictured above. Always had problems with the actual Assy of them put on or seated correctly. My guess is they will go with a stick on as well (Chrysler fashion) as then they wont have to stamp out different sheet metal just for a low volume Demon (Maybe not)