Results 1 to 1 of 1

Thread: R302 based 359" Shortblock Built for Boost

  1. #1
    Forum Member
    Join Date
    Mar 2005
    Location
    Port Huron, MI
    Posts
    2,348

    Default R302 based 359" Shortblock Built for Boost

    Selling an R302 based 359" shortblock. All parts are 100% new and unused with the exception of the block (was used when it was smaller 4.030" bore) and the oil pan.

    -FRPP R302 Block
    -3.400" stroke
    -5.400" rod
    -4.100" bore
    -Set up for High Ports
    -Other inline heads may work (this is on the buyer to verify)

    -Forged Eagle crank
    -Forged Eagle h-beam rods with ARP 2000 bolt upgrade
    -Custom Bennett Spec Ross Pistons with small dome (2.95cc)
    -Thick wall tool steel pins
    -Internal balanced
    -AP Tool Steel rings gapped for big boost
    -Clevite HP bearings throughout ; rod bearings hand radiused on fillet side
    -ARP studs throughout
    -Precision blueprinted oil pump ; standard volume, high pressure spring and shimmed
    -Canton windage tray
    -Canton pickup
    -Canton 7 quart oil pan ; tapped for oil return

    Does not come with:

    -Harmonic damper
    -Timing chain set
    -Cam
    -Oil pump driveshaft
    -Anything else not listed above

    With a 68cc chamber and 0.052" gasket, static compression ratio is 10.25:1

    Rotator is properly clearanced/assembled, but oil pump/windage tray/pickup/pan are not installed.

    Would cost roughly $8,000 to duplicate this setup as it sits - if you can even find an R302 block to begin with.

    $4000 picked up. Located in Port Huron, Michigan. Serious buyers can come look in person.

    No trades and no pic collectors.

    810-990-9842 is my cell since I don't check here often.
    Last edited by PaxNovi 5.0; 02-20-2021 at 08:31 PM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •