anyone have good recomendations?
he has a Spohne trans crossmember and torque arm already, so ones that include those are not needed
damn caps lock
anyone have good recomendations?
he has a Spohne trans crossmember and torque arm already, so ones that include those are not needed
damn caps lock
ASE Master Certified Technician
Why not do the spohn sfc? I think they are still the best avaliable pre-fabbed piece. Welding required.
Denny Villemure
PSSSSSSST!
Vortec 4200 Turbo IROC-Z on 15psi
10.85 @ 126mph
yeah, i am thinking about that one
i really liked the Alston racing bolt ins(I had them bolted and welded) i had on the IROC, but they would hurt ground clearance int he fact that you can't tuck the exhaust up quite as tight, the Spohn one look pretty good, not a bad price either
Last edited by dave89iroc; 07-16-2008 at 07:54 PM.
ASE Master Certified Technician
i am also looking for some connecters if ne one has ne or noes where i could get some for around 200 bucks please letme no not tryin to steal ur question or w/e lol
spohn..look them up.
Denny Villemure
PSSSSSSST!
Vortec 4200 Turbo IROC-Z on 15psi
10.85 @ 126mph
have to go weld in. my southwests have been great on the hardtop. which i could track down another set. paid $130 welded in and everything but that was back in 2000. If J&M made a set for the 3rdgen i'd pick them up. probably go with bmr otherwise.
i have a set of bmr's and really like how they bolted around the rear control arm and then tied in up front
2x2 square tubing+ MIG = poor mans SFC lol
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks