Results 1 to 7 of 7

Thread: Think these would work?

  1. #1
    Club Member MidnightG6V6's Avatar
    Join Date
    Oct 2008
    Location
    trying to find myself........
    Posts
    1,688

    Default Think these would work?

    Well ever since i lowered my car the camber has been off on my back tires. i went and had some work done to fix them some but they are still off. i was looking on line and i found these http://www.pfyc.com/pc/GN4009/G6SUSP...ment+Kits.html
    can anyone help me and tell me if these should do the trick, went to the dealer but they said they thought so but not 100% sure

    thanks in advance for any help

  2. #2
    Club Member
    Join Date
    Jan 2005
    Location
    Bestside, MI
    Posts
    4,249

    Default

    It should, cheap enough to try and see if it helps
    Chris White
    2022.5 Sierra Denali LM2
    2022 XT5 Sport
    2022 C8 3LT Coupe
    2022 ZL1
    2023 Escalade V

  3. #3
    Club Member MidnightG6V6's Avatar
    Join Date
    Oct 2008
    Location
    trying to find myself........
    Posts
    1,688

    Default

    how would i know how many degrees off my cambers are? cuz it says each one is good for +/- 1 degree so if im 2 degrees i would need 2 sets

  4. #4
    Club Member
    Join Date
    Jan 2005
    Location
    Bestside, MI
    Posts
    4,249

    Default

    Take it to an alignment shop IE belle tire and see if they can take up the extra slack first. Worst case scenario they should be able to tell you how far out of spec it is and go from there.
    Chris White
    2022.5 Sierra Denali LM2
    2022 XT5 Sport
    2022 C8 3LT Coupe
    2022 ZL1
    2023 Escalade V

  5. #5
    Club Member MidnightG6V6's Avatar
    Join Date
    Oct 2008
    Location
    trying to find myself........
    Posts
    1,688

    Default

    sounds good

  6. #6
    Club Sponsor
    Join Date
    Nov 2003
    Location
    W-town
    Posts
    5,210

    Default

    Depending on the strut these do not take up enough camber if the car has been lowered more then 2 inchs. At that point you most likely need to modify the strut tower and lower control arm pickup points to get the needed amount of adjustment.

  7. #7
    Club Member MidnightG6V6's Avatar
    Join Date
    Oct 2008
    Location
    trying to find myself........
    Posts
    1,688

    Default

    well the kit that i put on my car was only a 1.4" lowering kit but after it settled its a little more but should be less than 2 inches

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •