Line Lock and 2-Step Wiring Diagram Question

[5SpeedSteed]

This is my first time wiring up my line lock and 2 step for my Fox Mustang. I want to make sure the wiring diagram I have created will allow me to do the following:

1. Use the line lock to burnout
2. Use the line lock and the MSD 2-Step in my Digital 6 to launch

Could someone verify I have devised the proper wiring diagram?

I understand wiring diagrams and how to make them, but just want to make sure its correct before I start wiring it!

Thanks!

[dave89iroc]

what does the red wire from the 2 step do? just a signal to the MSD for the rev limiter?

as shown, the line lock will stay applied once engaged until the ground is removed from pin 86

[5SpeedSteed]

what does the red wire from the 2 step do? just a signal to the MSD for the rev limiter?

as shown, the line lock will stay applied once engaged until the ground is removed from pin 86

The red wire into the Digital 6 box will signal the 2 step rev limiter (launch RPM limit).

Just so I understand, if I press the momentary button the line lock will engage. It I have the clutch and the momentary button pressed it will turn on the line lock and 2 step until I release the clutch.

[dave89iroc]

is the clutch switch triggered when the clutch is depressed? if so

the way it is shown, hit the clutch, tap the momentary switch, and the line lock will stay engaged until clutch is released, irregardless of the momentary switch condition


if you want both the clutch switch AND the momentary switch to be able to disengage the line lock, let me know and i will change your diagram