1) Have 4"x2"x3/16" rectangular tubing mandrel bent locally?
2) Have an axle assembly checked for straightness?
Thank you!
1) Have 4"x2"x3/16" rectangular tubing mandrel bent locally?
2) Have an axle assembly checked for straightness?
Thank you!
Last edited by monster.; 09-12-2009 at 01:43 PM.
The only way around, is through
That's true, they are really close too. Thank you!
The only way around, is through
WHERE CAN I BEND UP 3x4" rectangular tubing
The only way around, is through
I don't know of any personally,
but here is a link
http://detroit-mi.yellowusa.com/Tube...bricating.html
I don't think you are going to be able to bend square tube. I think what you'll have to do is cut a wedge from it and tweak it, but then it will have to be welded as well. If you bend it, I think it would kink?
Thanks for the replies guys, I found a few different companies that will mandrel bend it up. I'd rather bend it then cut and weld it. I just have to find the time and bring it in.
Thanks again,
Dave
The only way around, is through
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks