Trying to fit a prostar 15x10 on a 82 stang. Looks like it hits right where the rear spring goes. Not sure I can "modify it any more. Any ideas? I'll post some pics tomorrow.
Trying to fit a prostar 15x10 on a 82 stang. Looks like it hits right where the rear spring goes. Not sure I can "modify it any more. Any ideas? I'll post some pics tomorrow.
Another proud member of Dang-o Racing!!
I think where most of you have your problems with all of this, is the fact that you really don't fully understand the internal workings and dynamics of the common combustion engine. There is no magic tune up, and motors are stupid. The only time a motor will complain is when something is wrong.
Whats your back space? Some guys I know run a small spacer(not sure on size) on the 6.5" backspace rim.
i run a 5/16 spacer with a 6.5 in backspace hope that help's ya!
i have done it without a spacer, lots-o-hammerin
a small spacer makes it much easier
They'll fit. I was running Bogarts with 6.25 bs and had to beat just a little. One side needed a small spacer. Now the rear is narrowed 1.5" per side with some Alumastars and a 6" bs...that needed a lot of beating, but now there nice and tucked
yeah they will fit, also when the car is at ride height it helps too. if the rear is just hanging there it will rub bad... but a big hammer and some sweat you will get it... and the spacer will get the rest of it, but its best to try and get it without a spacer...
ill make ya famous...
WWW.JOHNQUICKRACING.COM
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks