V-6 to a V-8 swap?

[MotorCityNova572]

How hard would it be to swap a 306 over into my mustang that is a v6? I know alot needs to be done, i am just woundering what are some things i will run into... My step brother have a 306 and i was thinking with in the next year or so i would do the swap..

[orangejuiced86]

I think a new kmember would be all you need.

[Sean]

Find a clapped out v8 car to strip for parts. Things like accesory brackets,steering shaft, etc start to get pricey one part at a time. but a non running v8 rust bucket full of parts for $500 is a good investment for a swap like this.

[82hatch]

I think a new kmember would be all you need.

x2

[orangejuiced86]

To set the engine in you just need the right kmember and mounts. To get it running is another story.

[BB71Mopar]

If it is carbed than it wouldn't be too bad. fuel press reg, ignition, exhaust, and it all depends on if you want it as a DD...

[MotorCityNova572]

If it is carbed than it wouldn't be too bad. fuel press reg, ignition, exhaust, and it all depends on if you want it as a DD...

yea its going to be a DD i dont want to get to crazy with anything. Just a nice set up that will start everytime and be taking for nice days...something to play with

[BB71Mopar]

if you want a good DD than I would check on here or at a junk yard for a fuel injection set up. You will need the harness, computer, distributor, upper and lower intakes and fuel rails. There is probably a few guys on here that have almost all that stuff they want to off.