Learning_to_Weld-4407 by Jason Bacon, on Flickr
Learning_to_Weld-4408 by Jason Bacon, on Flickr
Learning_to_Weld-4409 by Jason Bacon, on Flickr
Learning_to_Weld-4407 by Jason Bacon, on Flickr
Learning_to_Weld-4408 by Jason Bacon, on Flickr
Learning_to_Weld-4409 by Jason Bacon, on Flickr
Sheet metal is fun to work with but tough because it's easy to burn through.
What PSI do you have your gas set to?
Also, same as paint work, prep is one of the most important steps. Clean all rust and contaminants off of the metal prior to welding.
I have the gas set at roughly 20CFH.
It's not amazeballs, fabricator good but, its better than it was. Its held in there well and who ever puts the cage into the car and finish it off as they please.
Learning_to_Weld-4410 by Jason Bacon, on Flickr
Learning_to_Weld-4411 by Jason Bacon, on Flickr
Stupid spot weld bit broke with one weld left to drill out.
Learning_to_Weld-4418 by Jason Bacon, on Flickr
Stuff and things are happening.
Cell phone pictures from the guy doing the work. Next weekend, I'll drag it home, clean it up and get some paint on things.
22908342_2027147194188920_958109417_o by Jason Bacon, on Flickr
22908713_2027147174188922_1934768494_o by Jason Bacon, on Flickr
23022990_2027159894187650_1901194546_o by Jason Bacon, on Flickr
22901383_2027115584192081_1372095006_n by Jason Bacon, on Flickr
23023035_2027147204188919_1120753711_o by Jason Bacon, on Flickr
23023277_2027147374188902_206760780_o by Jason Bacon, on Flickr
23030879_2027159910854315_327938248_o by Jason Bacon, on Flickr
Nice dick motor plates lol
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks