3 pedals..... should be a fun ride this year!

**orangejuiced86** · 04-24-2007, 10:07 PM

sure, whenever I get to it. Car isnt ready yet. Its going to pacecars shop this week to have headers built.

**1BADAIR** · 04-24-2007, 10:08 PM

I need some 1 7/8 headers and they are expensive

**orangejuiced86** · 04-24-2007, 10:11 PM

ya, thats what I am having built.

**NVR2FST** · 04-24-2007, 10:29 PM

I ran a Spec Stg. 3 with a Gforce in my Pure Street car and never had any problems. There are people running Centerforce, Spec, ACT etc. in the class.

Once you go with an alum. flywheel, plan on launching approx. 500rpm or so higher....

Originally Posted by QuickLX

I can't remember the exact cost off the top of my head, but I think it was around $500 for everything. You should give Liberty's a call to be sure though. I had 2nd, 3rd, and 4th done. It is definately a little noisy and sometimes makes a clunking noise if you are cruising in gear, let off the throttle, and then stab it again (not near as bad as I thought it would be, in fact its barely noticeable). Also, shifting it just cruising around town will take some getting used to, as well as getting used to down-shifting it. The down shifts are the fun ones, and sometimes noisy.. These things a minor annoyances that you will get used to, but the benefits are incredible. Hell, I was impressed with how it shifted at 5500 RPM and never expected it to get better, but when I wound it up to 7500 RPM I could not believe how effortlessly it went into gear. You will not be dissappointed.